Hi,

could you add a little info to each new firmware, which has changed with the new firmware.

Or what problem was solved with it.

What is different at the 26.3.40 than at the 26.3.32

Dear Pincho,

where do you find the new firmware for R26* ?

Thanks Andreas

AMCS wrote:Dear Pincho,

where do you find the new firmware for R26* ?

Thanks Andreas

Hi,

Please find the new firmware of R26 from this link viewtopic.php?f=34&t=12

Best regards

Pincho wrote:Hi,

could you add a little info to each new firmware, which has changed with the new firmware.

Or what problem was solved with it.

What is different at the 26.3.40 than at the 26.3.32

Hi Pincho,

I help to add the change log. Please check it in the link viewtopic.php?f=34&t=12

Best regards

For the newer release there is no Changelog published.
Please implement a release workflow that includes releasing Changelog information.

viewtopic.php?f=34&t=12&sid=c0bf2cd8cdaa9dcd7435cf54729c5180#p533

Thanks !

Hi Sir,

Thank you so much for your advice. We have improved release workflow.

Please see the attached link:
viewtopic.php?f=31&t=207

The new software 26.31.3.255 you have specified under point 3 that now an external ringing bell is possible.
how is this connected?

Can you please set us a connection diagram for the external chimebell.

Pincho wrote:Can you please set us a connection diagram for the external chimebell.

Hi,
For the chime bell connection diagram, you can refer to the picture below.


In addition, you need to go to the path Intercom->Basic->Chimebell setting on the web to configure. Which relay to configure depends on your connection.


Thanks.

Hi,

it worked. I connected it to the relay B. Here you can set the time how long it is active.

In my Chimebell would be another option gut.one can specify the number of pulses. Not only the duration of how long the relay should be active.

My chimebell needs a short impulse. So that the chimebell rings several times. Is that possible?