3xIT82 in one house

[connermacleod69]

Hi,
first I must say that the software design of the last firmware update is better than the old ones! Thanks!
Now my question: we have rebuild a hous for a customer. It has 3 floors. The owner wants an IT82 on each floor. On the entry of the house I have one R26C. What do I have to to on the 3 IT82 an on the R26C that ALL 3 IT82 will ring? I read on the R26 manual page 20

Intercom Call
3.4.1. Direct IP Call
Without sip server, users can also use IP address to call each other,
but this way is only suitable in the LAN.
Go to Phone - Call Feature to enable the direct IP call for door
phones first.
Then, go to Intercom - Basic to configure the IP address of the
destination(E.g. IP address 192.168.1.100). It supports up to 8
lines simultaneously.

but this does not work?
I have 4 fix ipaddresses, no SIP accounts.
I did some testings with IT82 some time ago (old firmware) with a raspberry pi with ASTERIX as PBX an calling a group of phones is no problem.

Thanks for your help.

Serge

[connermacleod69]

Hi,
it works !?
- I upgraded R26C to firmware R26C-26.31.4.110 from Wed Mar 27, 2019 8:39 am.
- I changed from Edge to Chrome.
Regards,
Serge

[Akuvox_Evelyn]

Hi,
first I must say that the software design of the last firmware update is better than the old ones! Thanks!
Now my question: we have rebuild a hous for a customer. It has 3 floors. The owner wants an IT82 on each floor. On the entry of the house I have one R26C. What do I have to to on the 3 IT82 an on the R26C that ALL 3 IT82 will ring? I read on the R26 manual page 20

Intercom Call
3.4.1. Direct IP Call
Without sip server, users can also use IP address to call each other,
but this way is only suitable in the LAN.
Go to Phone - Call Feature to enable the direct IP call for door
phones first.
Then, go to Intercom - Basic to configure the IP address of the
destination(E.g. IP address 192.168.1.100). It supports up to 8
lines simultaneously.

but this does not work?
I have 4 fix ipaddresses, no SIP accounts.
I did some testings with IT82 some time ago (old firmware) with a raspberry pi with ASTERIX as PBX an calling a group of phones is no problem.

Thanks for your help.

Serge

Hi sir,
You did the right thing. But I am not sure if your configuration is corrected. Have you confirmed they work on the same LAN? If possible, can you share me how do you configure it please?

Thanks&Best regards.

[connermacleod69]

Hi,
The customer uses it actually only in his LAN. As I wrote in the second post it works. All 3 IT82 get the signal from RC26C. I can open the door on all 3 IT82. The only little problem I still have is the Monitor button on the main screen as I wrote to your colleague Jon.
Regards,
Serge